{"product_id":"1pc-39-37-78-74inch-stair-edge-protector-nonslip-stair-nose-edging-self-adhesive","title":"1PC 39.37\/78.74Inch Stair Edge Protector NonSlip Stair Nose Edging Self-Adhesive","description":"\u003cul\u003e\n\u003cli dir=\"ltr\" aria-level=\"1\"\u003e\n\u003cp dir=\"ltr\" role=\"presentation\"\u003e\u003cspan\u003e1 Piece\u003c\/span\u003e\u003c\/p\u003e\n\u003c\/li\u003e\n\u003cli dir=\"ltr\" aria-level=\"1\"\u003e\n\u003cp dir=\"ltr\" role=\"presentation\"\u003e\u003cspan\u003ePVC Material\u003c\/span\u003e\u003c\/p\u003e\n\u003c\/li\u003e\n\u003cli dir=\"ltr\" aria-level=\"1\"\u003e\n\u003cp dir=\"ltr\" role=\"presentation\"\u003e\u003cspan\u003eSolid Colour Finish\u003c\/span\u003e\u003c\/p\u003e\n\u003c\/li\u003e\n\u003cli dir=\"ltr\" aria-level=\"1\"\u003e\n\u003cp dir=\"ltr\" role=\"presentation\"\u003e\u003cspan\u003eSelf-Adhesive Stair Edging\u003c\/span\u003e\u003c\/p\u003e\n\u003c\/li\u003e\n\u003cli dir=\"ltr\" aria-level=\"1\"\u003e\n\u003cp dir=\"ltr\" role=\"presentation\"\u003e\u003cspan\u003eAvailable in 1m and 2m Length Options\u003c\/span\u003e\u003c\/p\u003e\n\u003c\/li\u003e\n\u003c\/ul\u003e\n\u003ch2 dir=\"ltr\"\u003e\u003cspan\u003eSimple Protection for Exposed Stair Edges\u003c\/span\u003e\u003c\/h2\u003e\n\u003cp dir=\"ltr\"\u003e\u003cspan\u003eThis PVC stair edge protector is designed to cover the front edge of a step, where repeated foot contact can gradually mark or wear the underlying surface. It creates a defined finish across the stair nose while adding a non-slip contact area at a frequently used part of the step.\u003c\/span\u003e\u003c\/p\u003e\n\u003cp dir=\"ltr\"\u003e\u003cspan\u003eThe edging is supplied as one continuous piece and is available in two length options. The 39.37-inch version is approximately 1 metre long, while the 78.74-inch version provides approximately 2 metres of coverage. The most suitable option will depend on the width and number of stair edges being completed.\u003c\/span\u003e\u003c\/p\u003e\n\u003ch2 dir=\"ltr\"\u003e\u003cspan\u003eSelf-Adhesive Fitting Without Mechanical Fixings\u003c\/span\u003e\u003c\/h2\u003e\n\u003cp dir=\"ltr\"\u003e\u003cspan\u003eA self-adhesive backing allows the stair edging to be installed without visible screws. This can make it a practical option for straightforward improvement or repair projects where drilling into the step is not preferred.\u003c\/span\u003e\u003c\/p\u003e\n\u003cp dir=\"ltr\"\u003e\u003cspan\u003eThe existing stair surface should be clean, dry and free from dust, grease or loose material before installation. Adhesive performance depends on the condition and compatibility of the underlying surface, so the edging should be dry-positioned and checked before the protective backing is removed.\u003c\/span\u003e\u003c\/p\u003e\n\u003cp dir=\"ltr\"\u003e\u003cspan\u003eFirm, even pressure should be applied along the complete length after positioning. Particular attention should be given to both ends and the front edge, as poorly bonded sections may lift during use.\u003c\/span\u003e\u003c\/p\u003e\n\u003ch2 dir=\"ltr\"\u003e\u003cspan\u003ePVC Construction for Everyday Stair Areas\u003c\/span\u003e\u003c\/h2\u003e\n\u003cp dir=\"ltr\"\u003e\u003cspan\u003eThe edging is manufactured from PVC and has a plain, solid-style finish. Its straightforward appearance allows it to be used where a functional stair-edge covering is preferred over a decorative metal profile.\u003c\/span\u003e\u003c\/p\u003e\n\u003cp dir=\"ltr\"\u003e\u003cspan\u003ePVC also makes the trim easier to handle during positioning than many rigid stair-nosing systems. However, the product should still be aligned carefully so that it follows the stair edge evenly without folds, raised sections or unnecessary tension.\u003c\/span\u003e\u003c\/p\u003e\n\u003cp dir=\"ltr\"\u003e\u003cspan\u003eThe supplied information does not specify a colour, profile width or thickness. These details should therefore be checked from the selected product option or accompanying images before ordering.\u003c\/span\u003e\u003c\/p\u003e\n\u003ch2 dir=\"ltr\"\u003e\u003cspan\u003eChoosing Between the Two Length Options\u003c\/span\u003e\u003c\/h2\u003e\n\u003cp dir=\"ltr\"\u003e\u003cspan\u003eThe 1m option is suitable where a single stair edge measures less than one metre or where the material will be cut for a smaller application. The 2m option provides additional coverage and may be more practical when completing wider steps or cutting sections for more than one stair edge.\u003c\/span\u003e\u003c\/p\u003e\n\u003cp dir=\"ltr\"\u003e\u003cspan\u003eMeasure every step separately rather than assuming the complete staircase has identical dimensions. Small differences in width can affect how much material is required, particularly when several sections are being cut from one piece.\u003c\/span\u003e\u003c\/p\u003e\n\u003cp dir=\"ltr\"\u003e\u003cspan\u003eWhen trimming is necessary, mark the required length before cutting and use equipment suitable for PVC. A straight, clean edge will help the installed protector sit more neatly against the sides of the staircase.\u003c\/span\u003e\u003c\/p\u003e\n\u003ch2 dir=\"ltr\"\u003e\u003cspan\u003eSurface Preparation and Final Positioning\u003c\/span\u003e\u003c\/h2\u003e\n\u003cp dir=\"ltr\"\u003e\u003cspan\u003eBefore installation, remove any loose dust and clean the stair edge using a method appropriate for the existing floor material. The surface must be allowed to dry fully before the adhesive backing is exposed.\u003c\/span\u003e\u003c\/p\u003e\n\u003cp dir=\"ltr\"\u003e\u003cspan\u003eBegin at one end of the step and gradually position the protector across the edge. Avoid removing the entire backing too early, as this may make alignment more difficult. Once installed, inspect the complete length to confirm that the trim is flat and that no sections are lifting.\u003c\/span\u003e\u003c\/p\u003e\n\u003cp dir=\"ltr\"\u003e\u003cspan\u003eThis product is intended as a self-adhesive stair-edge covering. It should not be treated as a repair for damaged, unstable or structurally unsafe steps, which must be addressed before any finishing trim is applied.\u003c\/span\u003e\u003c\/p\u003e\n\u003ch2 dir=\"ltr\"\u003e\u003cspan\u003eFrequently Asked Questions\u003c\/span\u003e\u003c\/h2\u003e\n\u003ch3 dir=\"ltr\"\u003e\u003cspan\u003eWhat lengths are available?\u003c\/span\u003e\u003c\/h3\u003e\n\u003cp dir=\"ltr\"\u003e\u003cspan\u003eThe stair edge protector is available in approximately 1m and 2m lengths. The listed imperial measurements are 39.37 inches and 78.74 inches respectively. Measure the required stair coverage before selecting an option, allowing for any cutting or fitting adjustments.\u003c\/span\u003e\u003c\/p\u003e\n\u003ch3 dir=\"ltr\"\u003e\u003cspan\u003eIs one piece or a pair supplied?\u003c\/span\u003e\u003c\/h3\u003e\n\u003cp dir=\"ltr\"\u003e\u003cspan\u003eThe supplied information describes this as a single-piece package. One continuous stair edge protector is therefore included. The number of steps that can be covered will depend on the selected length and the measured width of each stair.\u003c\/span\u003e\u003c\/p\u003e\n\u003ch3 dir=\"ltr\"\u003e\u003cspan\u003eHow is the edging installed?\u003c\/span\u003e\u003c\/h3\u003e\n\u003cp dir=\"ltr\"\u003e\u003cspan\u003eThe protector has a self-adhesive installation method. The stair edge should be cleaned and dried before fitting. Remove the backing gradually, align the material carefully and apply firm pressure across the complete surface to support an even bond.\u003c\/span\u003e\u003c\/p\u003e\n\u003ch3 dir=\"ltr\"\u003e\u003cspan\u003eDoes installation require screws?\u003c\/span\u003e\u003c\/h3\u003e\n\u003cp dir=\"ltr\"\u003e\u003cspan\u003eNo screw-down installation is specified for this product. It is intended to be fitted using its self-adhesive backing. However, adhesion will depend on the material, cleanliness and condition of the existing stair surface.\u003c\/span\u003e\u003c\/p\u003e\n\u003ch3 dir=\"ltr\"\u003e\u003cspan\u003eCan the PVC edging be cut to size?\u003c\/span\u003e\u003c\/h3\u003e\n\u003cp dir=\"ltr\"\u003e\u003cspan\u003ePVC edging can normally be shortened using a suitable cutting tool. Measure and mark the required section before cutting, and ensure the finished edge is straight and smooth so that it sits neatly against the side of the step.\u003c\/span\u003e\u003c\/p\u003e\n\u003ch3 dir=\"ltr\"\u003e\u003cspan\u003eWill it stick to every type of flooring?\u003c\/span\u003e\u003c\/h3\u003e\n\u003cp dir=\"ltr\"\u003e\u003cspan\u003eCompatibility with every flooring material is not confirmed. Smooth, stable and properly cleaned surfaces generally provide better conditions for self-adhesive installation. Textured, dusty, damp or damaged surfaces may reduce the quality of the bond.\u003c\/span\u003e\u003c\/p\u003e\n\u003ch3 dir=\"ltr\"\u003e\u003cspan\u003eIs the colour shown in the specifications?\u003c\/span\u003e\u003c\/h3\u003e\n\u003cp dir=\"ltr\"\u003e\u003cspan\u003eNo specific colour has been provided in the supplied product information. The selected listing option and product images should be checked before purchase to confirm the colour and appearance of the edging.\u003c\/span\u003e\u003c\/p\u003e\n\u003ch3 dir=\"ltr\"\u003e\u003cspan\u003eIs this a replacement for repairing a damaged stair?\u003c\/span\u003e\u003c\/h3\u003e\n\u003cp dir=\"ltr\"\u003e\u003cspan\u003eNo. The protector is intended to cover and finish the stair edge. Loose flooring, damaged step surfaces or structural problems should be repaired first, as self-adhesive edging requires a stable base for proper positioning.\u003c\/span\u003e\u003c\/p\u003e","brand":"Rubber Fit Floors","offers":[{"title":"Default Title","offer_id":54477717340506,"sku":null,"price":32.48,"currency_code":"GBP","in_stock":true}],"thumbnail_url":"\/\/cdn.shopify.com\/s\/files\/1\/0907\/6516\/4890\/files\/s-l300.webp?v=1785146786","url":"https:\/\/www.rubberfitfloors.co.uk\/products\/1pc-39-37-78-74inch-stair-edge-protector-nonslip-stair-nose-edging-self-adhesive","provider":"Rubber Fit Floors","version":"1.0","type":"link"}